Fitting An Abrasive Wheel; Connecting Charger To Power Supply - Stihl TSA 230 Gebrauchsanleitung

10 Connecting Charger to Power Supply

► Use the combination wrench to loosen the
hexagon head screw (2)
► Release the spindle locking mechanism and
unscrew the hexagon head screw (2)
► Remove the front thrust washer (3) from the
shaft together with the abrasive wheel (4)
9.2

Fitting an abrasive wheel

► Fit the new abrasive wheel (4)
0458-707-9821-C
4
3
4
3
WARNING
Note the arrows indicating the direction of rota‐
tion on diamond abrasive wheels.
► Position the front thrust washer (3) so that the
words "TOP SIDE" are visible
► Screw in the hexagon head screw (2)
2
1
► Press and hold the spindle locking mecha‐
nism (1)
► Turn the shaft with the combination wrench
until the shaft is blocked
► Tighten the hexagon head screw with the
combination wrench – if using a torque
wrench, refer to the "Specifications" for the
tightening torque
WARNING
Never use two abrasive wheels at the same time.
The uneven wear creates a risk of breaking and
an injury hazard!
2
10 Connecting Charger to
Power Supply
Power supply (mains) voltage and operating volt‐
age must be the same.
English
49