Led On Charger; Connecting The Water Supply; Switching On; Inserting The Battery - Stihl TSA 230 Gebrauchsanleitung

13 LED on Charger

13 LED on Charger
1
The LED (1) on the charger may glow continu‐
ously green or flash red.
13.1 Green continuous light ...
... indicates the following:
– is being charged
– is too hot and must cool down before charging
See also "LEDs on battery".
The green LED on the charger goes off as soon
as the battery is fully charged.
13.2 Red flashing light ...
... may indicate the following:
– No electrical contact between battery and
charger – remove and refit the battery
– Malfunction in battery – see also "LEDs on
Battery".
– Malfunction in charger – have checked by a
servicing dealer. STIHL recommends an
authorized STIHL servicing dealer.
14 Connecting the water sup‐
ply
Only with wet cuts:
► Connect the hose to the water supply network
1
► Push the coupling (1) on to the hose connec‐
tor (2)
► when connected to the water supply network,
open the tap
0458-707-9821-C
3
2
► before starting work, open the shut-off
valve (3) and allow water to flow to the abra‐
sive wheel
The water flow rate can be set via the shut-off
valve (3).
After finishing work:
► Switch off the machine
► Close the shut-off valve (3).
► Disconnect the cut-off machine from the water
supply network
Water can also be supplied via the pressurized
water tank (special accessory).

15 Switching On

When delivered, the battery is not fully charged.
It is advisable to charge the battery completely
before using it for the first time.
► Before inserting the battery, remove the bat‐
tery compartment cover if there is one; to do
this, press both safety catches at the same
time – cover is unlocked – remove the cover
15.1

Inserting the battery

1
► Insert the battery (1) into the battery compart‐
ment of the machine – battery slides into the
compartment – press gently until it clicks into
place – top of battery must be flush with the
top edge of the housing
15.2 Switching on the machine
2
English
53