Cameo ZENIT W600 Bedienungsanleitung Seite 22

Dimmer = Dimmer curve
Curve
Dimmer = Dimmer sensitivity
Response
Color = Color calibration
Calibration (If one of the DMX
factory calibration
modes is activated,
no other calibration
can be selected and
the message "no
possible change in
this DMX Mode" will
be shown on the
display. If one of the
DMX user calibration
modes is activated,
RAW can be selected
as the alternative
calibration.)
Autolock = Automatic locking of
the controls
22
Linear Light intensity increases linearly with
DMX value
Exponential Light intensity can be finely adjusted at
lower DMX values and broadly adjusted
at higher DMX values.
Logarithmic Light intensity can be broadly adjusted at
lower DMX values and finely adjusted at
higher DMX values.
S-Curve Light intensity can be finely adjusted at
lower and higher DMX values and broad-
ly adjusted at medium DMX values.
LED Lamp responds abruptly to changes in
DMX value
Halogen Lamp behaves like a halogen spotlight
with slight brightness changes
RAW individual color calibration. Brightness
adjustment of 4 RGBW LED groups for all
modes in the range 000-255
User Individual color calibration. Cross-mode
calibration brightness setting of the 4 LED groups
RGBW with values from 000 - 255
Factory Factory-default calibration of R, G, B,
calibration and W (across all operating modes).
Select this setting to ensure the
consistent-looking presentation of color
macros in stand-alone mode and to
control color macros with DMX.
On Automatic locking of the controls after
approximately 1 minute of inactivity.
After attempted input the display shows:
"Locked!"
Unlock: press and hold UP and DOWN
simultaneously for approx. 5 seconds
Off Automatic locking of the controls is
disabled