Cameo ZENIT W600 Bedienungsanleitung Seite 21

DEVICE SETTINGS (Settings)
Press MODE to access the device settings selection menu (--- Menu ---). Using the UP and DOWN
controls, select the menu item "Settings" (observe arrow) and confirm with ENTER.
---------------- Menu ----------------
DMX Address
DMX Mode
Stand Alone
Slave
Settings
System Info
This will take you to the sub-menu for configuring the following sub-menu items (see table, select
with UP and DOWN, confirm with ENTER, change value or status with UP and DOWN, confirm with
ENTER):
Settings
Wireless = W-DMX settings
Setting (wireless DMX)
Display = Flip display
Reverse
Display = Display lighting
Backlight
DMX Fail = Operating status with
DMX signal fault
W-DMX On = W-DMX enabled
on/off
Off = W-DMX disabled
Operating Receive = W-DMX module as receiver
Mode
Transmit = W-DMX module as
transmitter
Transmitting G3 = G3 transmission standard
Mode
G4S = G4S transmission standard
Link Link = pair with W-DMX devices. W-DMX
must be activated on all devices and the
pairing must be picked up by a transmit-
ter (Receive Reset).
Unlink = unpair all devices
Receive No = do not retain transmitter pairing
Reset
Yes = retain transmitter pairing
On Rotate display by 180° (e.g. for overhead
installation)
Off No display rotation
On Permanent on
Off Deactivation after approximately
1 minute of inactivity
Hold Last command is retained
Blackout Activates blackout
Emergency Spotlight changes to color macro
Light "Cold White"
21