Cameo ZENIT W600 Bedienungsanleitung Seite 15

W-DMX™
1. To pair with W-DMX™-compatible transmitters, enable W-DMX™ in the device settings (Set-
tings -> Wireless Setting -> W-DMX On Off -> On) and reset the W-DMX™ module (Receive Re-
set -> Yes). Start the pairing process as described in the operating instructions of the W-DMX™
transmitter. Pairing is then completed automatically.
2. Pair a group of W-DMX™ devices to create a DMX universe with them. First decouple all
devices that should form the group (Settings -> Wireless Setting -> Receive Reset). Then select
a CLZW600 with a DMX controller via DMX cable and select "Transmit" in the settings (Settings
-> Wireless Setting -> Operating Mode -> Transmit). Select "Receive" in the settings of the
W-DMX™ device that you want to control via W-DMX™ (Settings -> Wireless Setting -> Operat-
ing Mode -> Receive), and pair it by selecting "Link" in the settings of the DMX cable
controlled CLZW600, then confirm your selection (Settings -> Wireless Setting -> Link -> Link).
Pairing is then completed automatically.
3. It is also possible to create a connected group of W-DMX™ devices via W-DMX™, and operate
them in master/slave mode. First decouple all devices that should form the group (Settings ->
Wireless Setting -> Receive Reset). In the settings (Settings -> Wireless Setting -> Operating
Mode) of the master unit select "Transmit", and in the settings of the slave units select "Receive".
On the master unit select "Link" (Settings -> Wireless Setting -> Link -> Link) and confirm your
selection by pressing ENTER. Pairing of the devices is then completed automatically. On the mas-
ter unit select one of the standalone modes (Auto, Color Macro, Static, Tunable White, User Color),
and use this to control the slave unit.
W-DMX™ STATUS
W-DMX™ W-DMX™
as receiver
deactivated
activated,
not coupled
W-DMX™ W-DMX
as receiver activated and
activated and coupled device,
device coupled, no DMX signal
Transmitter off,
or out of range
W-DMX™ W-DMX™
as reveicer and transmissi-
activated and on mode G3
coupled device, Arrow up = send
DMX signal is operation
present Down arrow =
Receive mode
Arrow flashing =
Coupling
Flashing stops =
Coupled
G3 G4S
W-DMX™
and transmissi-
on mode G4S
Arrow up = send
operation
Down arrow =
Receive mode
Arrow flashing =
Coupling
Flashing stops =
coupled
15