Setup - Somfy Dexxo Pro Rts Installationsanleitung

EN
6.2
Fig. 21 à 30
General electrical diagram (Fig. 21)
Photoelectric cells (Fig. 22)
A
B
This means that an automatic test is conducted to check
photoelectric cell operation every time the door operates.
Reflex photoelectric cell (Fig. 23)
This means that an automatic test is conducted to check photoelectric cell
operation every time the door moves.
Sensor bar (Fig. 24)
the door moves.
account the photoelectric cells or the sensor bar.
Orange light (Fig. 25)
-
-
Code keypad (Fig. 26)
Pedestrian door safety kit (Fig. 27)
If the pedestrian door contact is removed, the jumper between
terminals 5 and 6.
Battery (Fig. 28)
Aerial (Fig. 29)
Remote lighting (Fig. 30)
connection.
-
-
-
Siren
- Siren inactive "Pb" = 0.
"Pb" = 1 or "Pb" = 2.
-
7
"P2" = 2.
"P2" = 1.
"P2" = 1.
"P2" = 1.
"P1" = 0.
"P1" = 1.

7 - SETUP

7.1 Meanings of the various parameters
Total operating mode
Values 0: sequential
Comments P0 = 0: Each press on the remote control causes the motor to
move (initial position: door closed) as per the following cycle:
open, stop, close, stop, open...
-
- pressing a button on the remote control interrupts the
movement taking place and the timed close.
-
- pressing a button on the remote control during opening
- pressing a button on the remote control during closing
- pressing a button on the remote control during the timed
close restarts the timed delay.
seconds).
t0
not close. It will close once the obstacle is removed.
Orange warning light
Values 0: without advance warning
Comments
Safety input
Values 0: no safety mechanism
Comments
months.
Obstacle detection
sensitivity
Values
2: standard
detection complies with annex A of the standard EN 12 453.
Non-observance of this instruction can result in serious injury to persons,
e.g. when trapped by a door.
Copyright © 2017 SOMFY ACTIVITES SA. All rights reserved.
Dexxo Pro RTS
t0
t0
WARNING