NEC MultiSync LCD1510+ Bedienungsanleitung Seite 50

E - 12
7. To complete the setup of your MultiSync LCD monitor:
A. Set the resolution to 1024 x 768@75Hz.
B. Use the following OSM controls:
• Auto Adjust Contrast
• Auto Adjust
NOTE: Manual adjustment of the H/V Position and Image Adjust
H.Size/Fine controls may be required to complete setup of your
MultiSync monitor. For a full description of there OSM controls, refer
to the Controls section of this User's Manual.
NOTE: If you have any problems, please refer to the Troubleshooting
section of this User's Manual.
Please contact your local dealer for information about the Mac Adapter.
Cable Management
To use the cable management feature, lift up then remove back cover
(Figure CM.1). Place all cables into the vertical groove, leaving 15cm
of slack in the cables to allow the monitor to rotate between Landscape
and Portrait orientation (Figure CM.2). To replace back cover, push in
then slide down (Figure CM.3).
Raise and Lower Monitor Screen
The monitor may be raised or lowered in either Portrait or Landscape
mode. To raise or lower screen, place one hand under bottom of screen
(Figure RL.1), lift or lower slightly and simultaneously push the button
on the bottom back of the stand (Figure RL.2). Screen will lower while
button is pushed in. Release button to lock screen in place.
CAUTION: Although the monitor has been designed not to lower
automatically when the button is pushed, ALWAYS support the bottom
of the screen with one hand.
Installation