Herunterladen Inhalt Inhalt Diese Seite drucken

Troubleshooting - Heidolph Hei-TORQUE Core Betriebsanleitung

Vorschau ausblenden Andere Handbücher für Hei-TORQUE Core:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Troubleshooting

Troubleshooting
Troubleshooting
The following table shows possible faults and solutions:
Error (message)
Display remains dark
after switching on
Rotation cannot be
started, rotation
stops unexpectedly,
Overload
[
] error
message
Overheating
[
]
error message
If a fault cannot be rectified with the described suggestions, please contact an autho-
rized sales representative or our technical service (see section "Contact information
Heidolph international" on page 54).
Possible cause, remedy
No power supply
Check that the power plug is correctly connected
Electronic defect
Contact technical service
Motor or power supply unit is overloaded
Torque is too high
Blade is blocked
Rotation stops completely after two restart attempts
Remove blockage cause
Switch rotation back on again
Motor/Electronics too hot: Overheat protection has
tripped
Automatic shutdown. Allow the motor to cool and
switch the device back on
49

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis