Chuck For Stirrer Tools - Heidolph Hei-TORQUE Core Betriebsanleitung

Commissioning

Chuck for stirrer tools

WARNING
Risk of injury due to rotating parts
➜
The chuck is fixed on the stirrer shaft by a grub screw so that it cannot rotate:
Inserting and locking the chuck
➜ Push the chuck onto the stirrer shaft so that the screwed-in grub screw engages
in the assembly hole of the stirrer shaft and the chuck can thus be fixed securely
(above figure, right).
➜ Use the hex wrench supplied to turn the grub screw clockwise, in order to fix the
chuck.
Tighten the grub screw by hand only and with the help of the hex
wrench supplied.
Make sure that you do not overtighten the grub screw, as this
damages the thread.
Before mounting/dismantling the chuck, switch off the device
and disconnect it from the power supply to prevent unexpected
starting-up of the device!
42