Power Supply; Switching The Device On/Off - Heidolph Hei-TORQUE Core Betriebsanleitung

Commissioning

Power supply

The device has an appliance outlet with locking system for the power supply. A suitable
three-pole power supply cord is included in the scope of delivery.
DANGER
Electric shock, damage to property, loss of production
➜
Power cords without a locking system can become loose during
operation due to vibrations. In the event of an uncontrolled shut-
down of the stirrer tool, there is a risk of production downtime and
/ or property damage, e.g. due to an uncontrolled restart!
➜
Connect the power supply cord
➜ Before connecting the power supply cord, make sure that the main switch of the
device is in the OFF position (see following section "Switching the device on/off" on
page 44).
➜ Connect the cable coupling of the cord to the IEC appliance inlet on the back of the
device. Make sure that the locking system engages correctly.
➜
Connect the power supply cord to a properly secured mains socket-outlet.
Disconnect the power supply cord
➜
Switch OFF the device at the main switch before disconnecting the power supply
cord (see following section "Switching the device on/off" on page 44).
➜ Disconnect the mains connection cord from the mains socket-outlet.
➜
Press in the locking lever on the cable coupling and disconnect the power supply
cord from the IEC appliance plug on the back of the device.

Switching the device on/off

To switch the device on and off, use the main switch on the front of the device below
the control panel::
The device may only be supplied with the required line voltage
via a grounded power socket.
For reasons of operational safety, only use the supplied power
supply cord with locking system!
44