Clamping/Removing Stirrer Tools - Heidolph Hei-TORQUE Core Betriebsanleitung

Commissioning

Clamping/removing stirrer tools

WARNING
Risk of injury due to rotating parts
➜
Proceed as follows to clamp/remove stirrer tools:
➜
Turn the chuck clockwise to open it until the required stirrer tool can be inserted.
➜
Insert the stirrer tool into the chuck. Make sure that the working height is as
required!
➜
Hold the stirrer tool as close as possible to the middle, and close the chuck by
carefully turning it counterclockwise until the stirrer tool is tightly clamped.
The quick-action chuck can be overturned by excessive force
applied on opening! In this case, the quick-action chuck can no
longer be closed normally and a latching noise can be heard on
turning it in the closing direction.
Remedial action: Turn the quick-action chuck again in the opening
direction, beyond the latching point.
The quick-action chuck can then be operated normally again.
If necessary, stop the rotational movement and before clamping/
removing stirrer tools, switch off the device to prevent it from
starting up unexpectedly!
43