Automatic Restart - Heidolph Hei-TORQUE Core Betriebsanleitung

Commissioning

Automatic restart

This function can be used to set the device so that the stirrer is restarted automatically
after being switched off or after a power outage, and the speed is run up to the last set
value.
CAUTION
➜
➜
➜
Proceed as follows to activate/deactivate the automatic restart function:
➜ Switch on the device and use the speed controller to set the rotational speed value
213 rpm
to [ ]: Value has white background field.
➜ Wait for approx. six (6) seconds until the value is accepted: Value is displayed
without background field.
➜
Then use the speed controller to set the rotational speed values in chronological
214 rpm
order to [
until the value is accepted.
➜
As soon as the last value [
completed:
– On activating the function, the [
– In operation with active automatic restart, a small white caution symbol is
shown continuously at the top edge of the screen.
– On deactivating the function, the [
– As soon as the automatic restart function is deactivated, the warning symbol at
the top edge of the screen goes out.
On restarting after a power interruption, a [
triangle appears on the display briefly, the white caution symbol at
the top edge of the screen then flashes until the rotational move-
ment is stopped normally.
A power interruption that occurs during unsupervised operation can
be identified by this flashing function.
Always activate or deactivate the automatic restart function as
required before the actual process start!
Pay attention to the safety symbols on the device for signaling
the functional status for all process sequences.
If the automatic restart function is active, secure the device
with an information sign if necessary.
215 rpm 216 rpm
], [ ], [
217 rpm
] has been accepted, the status change is
restart on
restart off
217 rpm
] and [
] notice is displayed briefly.
] notice is displayed briefly.
Rotation
45
] and wait each time
] warning