Transportation; Storage; Acclimatization; Permissible Ambient Conditions - Heidolph Hei-TORQUE Core Betriebsanleitung

General notes
Compliance with and implementation of all relevant guidelines and safety measures for
the respective field of application is within the sole responsibility of the operator. All
risks resulting from improper use are solely borne by the operator.
The described product may only be operated by authorized and instructed personnel.
Training and qualification of the operating personnel as well as ensuring that the
product is operated with responsibility are the sole responsibility of the operator!

Transportation

During transportation, avoid strong vibrations and mechanical stresses that can cause
damage to the product. Keep the original packaging in a dry and protected place for
later use.

Storage

Always store the product in its original packaging. To protect against damage and
disproportionate material aging, store the device in a dry environment that is as
temperature-stable and dust-free as possible.
Recommended storage conditions:
• 5 °C – 31 °C up to 80 % rel. humidity
• 32 °C – 40 °C up to 50 % rel. humidity (decreasing linearly)

Acclimatization

After each transportation and after storage under critical climatic conditions (e.g. high
temperature difference between inside and outside), allow the product to acclimatize
at room temperature for a minimum of two hours to prevent possible damage from
condensation before putting it into operation in the place of use. If necessary, extend
the acclimatization phase if the temperature differences are very high.
Make all supply connections only after the product has been acclimatized!

Permissible ambient conditions

CAUTION
The product is not suitable for outdoor use!
The product is not suitable for use in potentially explosive
atmospheres!
Permissible ambient conditions for operation:
• 5 °C – 31 °C up to 80 % rel. humidity
• 32 °C – 40 °C up to 50 % rel. humidity (decreasing linearly)
• Maximum height above sea level: 2,000 m
When used in corrosive atmospheres, the life of the product may be reduced depending
on the concentration, duration and frequency of exposure.
34