Replacing Tracks; Storage - Zipper Maschinen ZI-MD300 Betriebsanleitung

14.2.10 Relaxing tracks
Check the condition of the tracks periodically. If any track is cracked or frayed, it should be replaced
as soon as convenient.
WARNING
When removing and replacing the chain, make sure that you pinching your hands between the
wheel and the chain.
14.3

Storage

If the machine is stored for longer than 30 days:
Let the machine cool down
•
Clean the machine and dry
•
Empty Tank and carburettor completely, avoid fuel spillage
•
Store in a dry, out of reach of children place, well packaged
•
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
ZI-MD300
CLEANING, MAINTENANCE, STORAGE, DISPOSAL
If the distance is greater, proceed as follows:
• Use the tipping handle to tip the dump box
and set it on blocks or supports rated for the
weight of the box.
• Loosen the locknut A. Tighten bolt B until
the correct tightness is restored.
• Secure bolt B by tightening locknut A thor-
oughly.
• Return the dump box to its original position
WARNING
The adjustment of the chains affect the brakes.
Please with great caution proceed as a chain
spanned loss of braking action results.
If the adjustment does not allow further ad-
justment more, the chain should be replaced.
• Tilting bring back to the starting position.
• Put machine on a flat surface with firm
ground.
• Lift the machine and set on blocks or sup-
ports, which can carry the weight of the
machine.
• Disassemble the dump box
• Loosen the locknut A and bolt B shown in
above figure to let the tracks loose enough
• Slip old tracks off and install the new tracks.
• Adjust bolt B to assure correct tightness
• Secure bolt B by tightening locknut A thor-
oughly.
• Re-mount dump box
41