Safe Working - Parkside PHKSA 12 B3 Originalbetriebsanleitung

GB
This information on the saw blade complies
with standard DIN EN 847-1:2017.
The tool may only be used by trai-
ned, experienced people who know
how to handle tools.

Safe working

• The maximum speed stated on the tool
must not be exceeded. If indicated, the
speed range must be complied with.
• Circular saw blades with cracks in them
must be taken out of service (repair is not
permitted).
• Tools with visible cracks must not be
used.
• Tools must be cleaned regularly.
• Tool parts made of light metal alloys,
e.g. resin, may only be cleaned with sol-
vents that do not impair the mechanical
properties of these materials.
• Tools and tool bodies must be tightened
in such a way that they cannot become
loose during operation. Please note the
information on assembly.
Tighten the clamping screw holding the
saw blade in place hand-tight using the
enclosed hex key.
• Extending a spanner or tightening with
the help of hammer blows is not permit-
ted.
• The tightening surfaces on the saw blade
must be cleaned to remove any dirt, gre-
ase, oil and water.
• Use original spare parts from the ma-
nufacturer to ensure safe use, see the
section "Spare parts/accessories".
• Maintenance work and modifi cations to
circular saw blades should only be per-
formed by a professional, i.e. a person
with specialist training and experience
who is familiar with the design require-
ments and the necessary safety steps.
2
ADDENDUM
Cleaning
• Remove any dirt, such as resin, from the
saw blade using only solvents that do
not impair the mechanical properties of
the saw blade.
• Try to clean resinous surfaces with a
damp, lukewarm cloth that has been
wrung out well. Make sure that no
liquids can get into the interior of the
housing!
Alternatively, you can use a special clea-
ner (resin solvent) or multispray. Please
take notice of the safety information and
instructions provided by the manufactu-
rer of the special cleaner/multispray.
Maintenance
• Check the saw blade for obvious defects
after each use and replace a blunt or
bent blade or one which has been da-
maged in some other way.
• Maintenance work on the saw blades,
such as repair or regrinding, should be
performed by a professional.
Storage
• Store the saw blade in a dry and dust-
proof location and out of reach of child-
ren.
IAN 391298_2201
74209729