Temperature Setting; Buttons And Indicators; Echnical Data - yuna FROSTER 100 Bedienungsanleitung

4.6 Temperature setting

WARNING! To disconnect the appliance from the mains, you must
unplug the appliance or use a cut-off device.
NOTICE! If you want to switch off the appliance for a longer period of time,
disconnect it
« D
ECOMMISSIONING
❖ The temperature of the appliance (= cooling or freezing level) can be set manually
by pressing the relevant button until the desired cooling or freezing level will be
indicated on the control panel (s. chapter 4.3 C

BUTTONS AND INDICATORS

❖ When you set a temperature (= cooling or freezing level), you set an average
temperature for the whole appliance. Temperatures inside each area may vary,
depending on how much food you store and where you place them. Ambient
temperature may also affect the actual temperature inside the appliance. When
you set the temperature of the appliance (= cooling or freezing level) these aspects
should be considered.
P : the colder the selected temperature setting (= high cooling
LEASE NOTE
/ freezing level), the longer the compressor operates to reach the set
cooling / freezing temperature.
The set cooling / freezing level can be changed as needed.
You can check the temperature inside the appliance using a suitable thermometer
(not included in the scope of delivery).
When the ambient temperature is extremely high (please observe the climatic class
of your appliance in chapter « T
(= cooling / freezing level) to a colder setting if needed; the energy consumption
may be increased. If the colder setting should cause strong formation of encrusted
ice, please select a lower setting.
Extremely high ambient temperatures and simultaneously operating at the coldest
setting may make the compressor operate permanently to keep the
temperature constant inside the appliance. Please observe the climatic class of
your appliance in chapter « T
Please observe chapter 4.6.4 « R
FREEZING LEVEL
from the mains
, ».
TEMPORARILY
).

ECHNICAL DATA

ECHNICAL DATA
ECOMMENDED SETTING OF THE COOLING OR
».
(unplug!). S.
ONTROL PANEL
»!), you can set the temperature
»!
also Chapter
:
OPERATING
72