Operation; Before Initial Operation; Setting Of The Temperature - yuna FEDORA EKG275 Bedienungsanleitung

4. Operation

WARNING! To disconnect the appliance from the mains, you must
unplug the appliance or use a cut-off device.

4.1 Before initial operation

WARNING! While unpacking, the packaging materials (polythene
bags, polystyrene pieces, etc.) should be kept away from children and
pets. CHOKING HAZARD! RISK OF INJURY!
NOTICE! Leave the appliance in an upright position for at least 4 - 6 hours
before you connect it to the mains to ensure, that the oil has flowed back
into the compressor.
NOTICE! If you use the appliance for the first time or the appliance has
been disconnected from the mains for a longer period of time, allow the
appliance to cool down for 3 until 4 hours on medium temperature setting
(s. chapter 4.3

SETTING OF THE TEMPERATURE

or frozen food in the appliance. If you place food in the appliance before it
has reached its normal operating temperature, the food can thaw and / or
spoil.
1. Remove all packaging materials.
2. Adjust the feet and clean the appliance (see chapter
).
MAINTENANCE
3. Do not start the appliance immediately after installation. Wait at least 4 - 6 hours
to ensure proper operation.
4. The settings of the temperature of the fridge can be adjusted manually by pressing
the relevant button until the desired temperature level will be indicated; s. chapter
4.3 S
ETTING OF THE TEMPERATURE
5. If operation was interrupted, wait 5 minutes before restart.
6. The appliance needs some time to balance temperatures when you have changed
the settings before or when you have stored additional food in the appliance. The
duration of this period of time depends on the range of the change, the ambient
temperature, the amount of food and the frequency of door-openings. When you
set the temperature of the appliance these aspects should be taken into account.
7. Operate the appliance according to the instructions described in the following
chapters.
) before you place any fresh
.
CLEANING AND
67