Troubleshooting - yuna FROSTER 100 Bedienungsanleitung

13. Wipe and dry the appliance (in- and outside) and door seals using dry and soft
cloths. Dry thoroughly!
14. After cleaning leave the door open for a while to aerate the appliance.
15. Connect the appliance to the mains again.
16. Switch on the appliance again using the « On / Off » -
17. If needed, set a new temperature (= cooling / freezing level); s. chapter 4.6
T
EMPERATURE SETTING
NOTICE! Never forget to reinstall the water drain plug inside the freezer
after the defrosting process!
NOTICE! If the appliance has been disconnected from the mains for a
longer period of time, allow the appliance to cool down for 3 until 4 hours
at following temperature setting before you place any fresh or frozen food
in the appliance: fridge mode, cooling level 2 / freezer mode, cooling level
3 (s. chapter 4.6 T
appliance before it has reached its normal operating temperature, the food
can thaw and / or spoil.

7. Troubleshooting

P
OSSIBLE CAUSE
T
1. The appliance has been switched off
for a while.
2. Too much or too hot food in the
appliance.
3. Door opened too often or too long. 3. Do not open the door too
1. The plug of the appliance is not
connected to the socket.
2. The plug has become loose.
et seq.)
EMPERATURE SETTING
M
ALFUNCTION
HE COMPRESSOR OPERATES FOR TOO LONG
T
HE APPLIANCE DOES NOT WORK AT ALL
BUTTON
et seq.). If you place food in the
M
EASURE
1. The appliance needs some time to
reach the preset cooling / freezing
temperature.
2. Remove any hot food.
often / too long.
1. Connect the appliance to the mains
properly.
2. Check the plug.
(s. chapter 4.4).
.
.
91