General Information - Morso VULCANO WOK BURNER Bedienungsanleitung

GENERAL INFORMATION

IMPORTANT
Read these instruction carefully prior
to use. Familiarise yourself with the
appliance before connecting it to it's gas
container. Keep these instructions for
future reference.
IMPORTANT
The wok burner must only be used with
the hose and regulator that is supplied
with the product! Do not mount any other
regulators or hoses to this product, as
this can a cause very serious hazard.
IF YOU SMELL GAS
1. Shut off gas to the Wok Burner at its
source, if possible.
2. Extinguish any open flame.
3. If odour continues immediately ,call
your gas supplier or fire department.
Replacement
control and hose connec-
tor shall be carried out using
Morsø genuine products only.
Contact your local dealer.
Gas Installation Codes
• Boilers must be used in accordance with the installa-
tion requirements of your gas supply authority.
• Boilers for use with bottled gas are labelled 'propanegas' .
Clearances
MinimumClearancesfromcombustiblematerials
be: Rear - 300mm Sides - 300mm Above - 2000mm
Specifications
Wok Burner specifications can be found on the data
label attached to the Wok Burner body.
of pressure
must
Hose & Regulator Safety
The regulator and hose assembly supplied with the
boiler are suitable for 1. Propane, 2. Butane, 3. Propane
& Butane mix Gas only.
The pressure regulator and hose assembly supplied
with the Wok Burner must be used. Replacement of
pressure control and hose connector shall be carried
out using Morsø genuine products only. Contact your
local dealer.
When connecting the hose and regulator assembly to
the gas cylinder, take care to avoid unnecessary twist-
ing of the flexible hose.
Twist
After the assembly has been secured, turn on the gas
and check for leaks by brushing a soap and water solu-
tion over all connections.
If you are unable to correct the leak by tightening the
connections, turn off the gas and contact the supplier
immediately.
Always ensure the Wok Burner is kept away from flamma-
ble materials and the gas cylinder clear of any heat source.
When changing over from an empty gas cylinder to a
full one , make sure this procedure is carried out in a
well ventilated location, outside, away from people and
away from any sources of ignition; such as nakedflames,
pilotflames, electric heaters/equipment.
Gas Cylinder Use & Safety
This is a 300mb pressure boiler and must only be used
with the supplied regulator. Your Wok Burner is de-
signed for use with 1. Propane, 2. Butane, 3. Propane &
Butane mix gas cylinders certified to the CE and UKCA
standards.
The gas cylinder should be filled by a reputable gas sup-
plier and visually inspected and re-qualified at each filling.
Always keep cylinder in an upright position. Always
close the cylinder valve when the Wok Burner is not in
use. Do not subject gas cylinder to excessive heat.
NEVER STORE YOUR GAS CYLINDER INDOORS.
If you store your Wok Burner indoors, ALWAYS disconnect
the gas cylinder first and store the cylinder safely outside.
Cylinders must be stored outdoors in a well ventilated
area out of reach of children, and must not be stored in
a building, garage or any other enclosed area.
Fold Perish
17