Read Me First - Morso VULCANO WOK BURNER Bedienungsanleitung

READ ME FIRST

LÆS MIG FØRST
Gas leak testing
Test for gaslækage
It is important that you leak test the BBQ before first use and every time the gas cylinder is refilled and
Det er vigtigt, at brænderen testes før første brug, og hver gang gasflasken efterfyldes og sluttes til kedlen igen.
reconnected to the BBQ.
To Complete Leak Test
Det er vigtigt, at kedlen testes før første brug, og hver gang gasflasken efterfyldes og sluttes til kedlen igen.
• Make sure all the control knobs are OFF.
Sådan udføres læktesten
• In a small container, mix up a solution of water and detergent/soap.
• Sørg for, at alle betjeningsknapper står på OFF.
• Mix the solution well (about the same concentrate as washing up water).
• Bland vand og vaskemiddel/sæbe i en lille beholder.
• Turn the cylinder ON by rotating the knob to open position.
• Bland godt (omkring samme koncentration som til opvaskevand).
• Using a brush or spay bottle apply the soap solution to the gas line and each join in the gas line including:
• Drej regulatoren på gasflasken til åben position.
- the gas connection at the inlet of the BBQ
• Brug en børste eller sprayflaske til at komme sæbeopløsningen på gasledningen og den enkelte forbindelse i
- all gas hose connections
gasledningen, herunder:
- the gas connection at the gas cylinder
- gasforbindelsen ved kedlens indgang
• If bubbles appear, there is a gas leak.
- alle gasslangeforbindelser
• If the leak is at the connection, re-tighten and re-seal.
- gasforbindelsen ved gasflasken
• If the leak is anywhere else or you cannot resolve the leak by tightening the connection DO NOT PROCEED.
• Hvis der kommer bobler, er der en gaslækage.
• Replace gas hose and regulator.
• Hvis lækagen er ved forbindelsen, skal den strammes og forsegles igen.
• Replace hose and regulators can be purchased from your local BBQ retail specialist.
• Såfremt lækagen er et andet sted, eller du ikke kan udbedre lækagen ved at stramme forbindelsen, MÅ DU
IKKE FORTSÆTTE.
• Udskift gasslangen og regulatoren.
• Slange og regulatorer kan købes fra din lokale Morsø Specialist. Med en original del fra Morsø Jernstøberi
A/S.
4 2
READ ME FIRST
READ ME FIRST
Gas leak testing
It is important that you leak test the BBQ before first use and every time the gas
It is important that you leak test the BBQ before first use and every time the gas cylinder is refille
reconnected to the BBQ.
reconnected to the BBQ.
To Complete Leak Test
To Complete Leak Test
• Make sure all the control knobs are OFF.
• Make sure all the control knobs are OFF.
• In a small container, mix up a solution of water and detergent/soap.
• In a small container, mix up a solution of water and detergent/soap.
• Mix the solution well (about the same concentrate as washing up water).
• Mix the solution well (about the same concentrate as washing up water).
• Turn the cylinder ON by rotating the knob to open position.
• Turn the cylinder ON by rotating the knob to open position.
• Using a brush or spay bottle apply the soap solution to the gas line and each joi
• Using a brush or spay bottle apply the soap solution to the gas line and each join in the gas line
- the gas connection at the inlet of the BBQ
- the gas connection at the inlet of the BBQ
- all gas hose connections
- all gas hose connections
- the gas connection at the gas cylinder
- the gas connection at the gas cylinder
• If bubbles appear, there is a gas leak.
• If bubbles appear, there is a gas leak.
• If the leak is at the connection, re-tighten and re-seal.
• If the leak is at the connection, re-tighten and re-seal.
• If the leak is anywhere else or you cannot resolve the leak by tightening the con
• If the leak is anywhere else or you cannot resolve the leak by tightening the connection DO NO
• Replace gas hose and regulator.
• Replace gas hose and regulator.
• Replace hose and regulators can be purchased from your local BBQ retail spec
• Replace hose and regulators can be purchased from your local BBQ retail specialist.
2
2
READ ME FIRST
READ ME FIRST
Gas leak testing Gas leak testing
It is important that you leak test the BBQ before first use and ev
Gas leak testing
reconnected to the BBQ.
It is important that you leak test the BBQ before first use and
reconnected to the BBQ.
To Complete Leak Test
• Make sure all the control knobs are OFF.
To Complete Leak Test
• In a small container, mix up a solution of water and detergent/
• Make sure all the control knobs are OFF.
• Mix the solution well (about the same concentrate as washing
• In a small container, mix up a solution of water and deterge
• Turn the cylinder ON by rotating the knob to open position.
• Mix the solution well (about the same concentrate as wash
• Using a brush or spay bottle apply the soap solution to the gas
• Turn the cylinder ON by rotating the knob to open position
- the gas connection at the inlet of the BBQ
• Using a brush or spay bottle apply the soap solution to the
- all gas hose connections
- the gas connection at the inlet of the BBQ
- the gas connection at the gas cylinder
- all gas hose connections
• If bubbles appear, there is a gas leak.
- the gas connection at the gas cylinder
• If the leak is at the connection, re-tighten and re-seal.
• If bubbles appear, there is a gas leak.
• If the leak is anywhere else or you cannot resolve the leak by t
• If the leak is at the connection, re-tighten and re-seal.
• Replace gas hose and regulator.
• If the leak is anywhere else or you cannot resolve the leak b
• Replace hose and regulators can be purchased from your loca
• Replace gas hose and regulator.
• Replace hose and regulators can be purchased from your lo
2
2