Morso VULCANO WOK BURNER Bedienungsanleitung Seite 76

READ ME FIRST
LÉAME
Gas leak testing
Prueba de escape de gas
It is important that you leak test the BBQ before first use and every time the gas cylinder is refilled and
Es importante que realice una prueba de escapes en el hervidor antes del primer uso y cada vez que se llene la
reconnected to the BBQ.
bombona de gas y se reconecte al hervidor.
To Complete Leak Test
• Make sure all the control knobs are OFF.
Para completar la prueba de escape de gas
• In a small container, mix up a solution of water and detergent/soap.
• Asegúrese que todos los pomos de control están apagados.
• Mix the solution well (about the same concentrate as washing up water).
• En un contenedor pequeño, mezcle una solución de agua y jabón o detergente.
• Turn the cylinder ON by rotating the knob to open position.
• Mezcle bien la solución (con la misma concentración que el agua jabonosa).
• Using a brush or spay bottle apply the soap solution to the gas line and each join in the gas line including:
• Encienda el regulador en la bombona de gas en la posición de apertura.
- the gas connection at the inlet of the BBQ
• Usando una esponja o un pulverizador, aplique la solución jabonosa en la línea del gas y en cada conexión en
- all gas hose connections
la línea del gas, incluyendo:
- the gas connection at the gas cylinder
- la conexión de gas en el acceso del hervidor
• If bubbles appear, there is a gas leak.
- todas las conexiones de las tuberías de gas
• If the leak is at the connection, re-tighten and re-seal.
- la conexión de gas en la bombona de gas
• If the leak is anywhere else or you cannot resolve the leak by tightening the connection DO NOT PROCEED.
• Si aparecen burbujas, hay un escape de gas.
• Replace gas hose and regulator.
• Si el escape está en la conexión, vuelva a ajustar y vuelva a sellar.
• Replace hose and regulators can be purchased from your local BBQ retail specialist.
• Si el escape está en otro lugar o no puede solucionar la pérdida ajustando la conexión NO SIGA ADELANTE.
• Sustituya la tubería de gas y el regulador.
• La tubería y los reguladores de sustitución pueden adquirirse en una tienda de barbacoas más cercana. Con
un repuesto original de Morsø Jernstøberi A/S.
76
2
READ ME FIRST
READ ME FIRST
Gas leak testing
It is important that you leak test the BBQ before first use and every time the gas
It is important that you leak test the BBQ before first use and every time the gas cylinder is refille
reconnected to the BBQ.
reconnected to the BBQ.
To Complete Leak Test
To Complete Leak Test
• Make sure all the control knobs are OFF.
• Make sure all the control knobs are OFF.
• In a small container, mix up a solution of water and detergent/soap.
• In a small container, mix up a solution of water and detergent/soap.
• Mix the solution well (about the same concentrate as washing up water).
• Mix the solution well (about the same concentrate as washing up water).
• Turn the cylinder ON by rotating the knob to open position.
• Turn the cylinder ON by rotating the knob to open position.
• Using a brush or spay bottle apply the soap solution to the gas line and each joi
• Using a brush or spay bottle apply the soap solution to the gas line and each join in the gas line
- the gas connection at the inlet of the BBQ
- the gas connection at the inlet of the BBQ
- all gas hose connections
- all gas hose connections
- the gas connection at the gas cylinder
- the gas connection at the gas cylinder
• If bubbles appear, there is a gas leak.
• If bubbles appear, there is a gas leak.
• If the leak is at the connection, re-tighten and re-seal.
• If the leak is at the connection, re-tighten and re-seal.
• If the leak is anywhere else or you cannot resolve the leak by tightening the con
• If the leak is anywhere else or you cannot resolve the leak by tightening the connection DO NO
• Replace gas hose and regulator.
• Replace gas hose and regulator.
• Replace hose and regulators can be purchased from your local BBQ retail spec
• Replace hose and regulators can be purchased from your local BBQ retail specialist.
2
2
READ ME FIRST
READ ME FIRST
Gas leak testing Gas leak testing
It is important that you leak test the BBQ before first use and ev
Gas leak testing
reconnected to the BBQ.
It is important that you leak test the BBQ before first use and
reconnected to the BBQ.
To Complete Leak Test
• Make sure all the control knobs are OFF.
To Complete Leak Test
• In a small container, mix up a solution of water and detergent/
• Make sure all the control knobs are OFF.
• Mix the solution well (about the same concentrate as washing
• In a small container, mix up a solution of water and deterge
• Turn the cylinder ON by rotating the knob to open position.
• Mix the solution well (about the same concentrate as wash
• Using a brush or spay bottle apply the soap solution to the gas
• Turn the cylinder ON by rotating the knob to open position
- the gas connection at the inlet of the BBQ
• Using a brush or spay bottle apply the soap solution to the
- all gas hose connections
- the gas connection at the inlet of the BBQ
- the gas connection at the gas cylinder
- all gas hose connections
• If bubbles appear, there is a gas leak.
- the gas connection at the gas cylinder
• If the leak is at the connection, re-tighten and re-seal.
• If bubbles appear, there is a gas leak.
• If the leak is anywhere else or you cannot resolve the leak by t
• If the leak is at the connection, re-tighten and re-seal.
• Replace gas hose and regulator.
• If the leak is anywhere else or you cannot resolve the leak b
• Replace hose and regulators can be purchased from your loca
• Replace gas hose and regulator.
• Replace hose and regulators can be purchased from your lo
2
2