Low Battery - Cembre B1350-C Bedienungsanleitung

3 SEC.
The capacitive menu selection button may not work if touched using objects or when wear-
ing gloves, therefore always operate it using a bare fi nger.
4.2) SELECTION SCREENS:
of the tool, can be changed by operating the touch button:
Enabling/disabling the LED Worklights
LED
ON
LED
OFF
Return to original factory settings / fi rmware version
When the "RESET" screen is displayed, return the tool to its factory setting by operating the touch
button for at least 3 seconds; a beep will confi rm the setting.
RESET
The RESET screen also shows the fi rmware version of the circuit board.
SW:S1J41413
4.3) WARNINGS:
these appear during operation and notify the operator of the status of the tool:
LOW BATTERY: replace the battery.
BATTERY
NOTE: when the battery Vage falls below a minimum safety threshold, the tool
will not start; although it is still possible to end the work cycle in progress.
BATTERY
BATTERY TEMPERATURE HIGH: remove the battery and wait until it cools down.
NO. OF CYCLES TO MAINTENANCE REACHED:
30001
the tool continues to work however, it is recommended that it is sent to CEMBRE
for a complete overhaul (see § 6).
NOTE: this message, together with a beep, will reappear when the tool has been
idle for 30 seconds.
11
To make a selected screen operational and appear at each start-up of the
tool, operate the touch button for at least 3 seconds; a continuous beep
will confi rm the setting.
control parameters that cannot be set as automatic upon start-up
(factory setting LED ON)
LED
OFF
3 SEC.
LED
ON
When the screen is displayed,
touch the button for at least 3 sec-
onds to deactivate for reactivate
operation of the LED Worklights
during tool use;
a continuous beep will confi rm
the setting.