Battery Status; Using The Battery Charger; Thorough Cleaning - Cembre B1350-C Bedienungsanleitung

Do not apply pressure to or stab at the touch button, a light touch using a bare finger is
sufficient. The command pulse is sent when the finger releases the button.
BATTERY 

2.8) Battery status

The battery is equipped with LED indicators that indicate the remaining battery life at any time
BATTERY
by pressing the adjacent button (P) (Ref. to Fig. 5):
4 LEDs illuminated: fully charged
2 LEDs illuminated: 50 % capacity
1 LED flashing: minimum charge, replace the battery.
With the battery inserted into the tool, the remaining
battery life can also be checked on the display, via touch
button selection (Ref. to § 4).
RESET
SW:S1J41413
The screen shown alongside indicates that the battery voltage has
dropped below a minimum safety threshold; under these conditions
the tool will not start,and it is necessary to recharge or replace the bat
tery. The approximate time to fully recharge a battery is about 100 miutes.
N
LED
After each working cycle, and after the extraction of the battery from the tool, an integrated
OFF
battery cut-off device will operate after 70 s approx.
Then the LED nearest to button (P) will flash 5 times each 14 s approx. The battery will be
3 SEC. LED
reactivated when it is reintroduced into the tool and the operating button is pressed.
ON
n
n

2.9) Using the battery charger

Carefully follow the instructions in the battery charger user manual.
r
3. MAINTENANCE
The tool is robust, completely sealed, and requires very little daily maintenance. Compliance with
si
the following points, should help to maintain its optimum performance:
i

3.1) Thorough cleaning

Dust, sand and dirt are a danger for any hydraulic device.
Every day, after use, the tool must be wiped with a clean cloth taking care to remove any residue,
especially close to pivots and moveable parts.
Do not use hydrocarbons to clean the rubber parts.
3.2) Storage case
When not in use, the tool should be stored and transported in the plastic case, to prevent damage.
The case, type VAL P39, is suitable for storing the tool, the accessories and up to 8 die sets and pre-
prepared compression connectors.
VAL P39: Size 520x432x126 mm (20.5x17.0x5.0 inches). Weight 2,6 kg (5.7 lbs).
9

F = 125.2 kN
m
Fp = 94.5 kN
30001

F = 14.07 ton
m

Fp = 10.61 ton
P = 692 bar
m
F = 125.2 kN
m
Pp = 522.3 bar
F = 102.3 kN
p
P = 692 bar
m
P = 10037 psi
m
P = 565 bar
p
Pp = 7575 psi
max.
BATTERY
BATTERY
1000
-29000
B1350
LED
13AB485
ON
LED
OFF
3 SEC.
(Ref. to Fig. 8)

F
m
ERROR
F
p

P
m
P

p
001


002


003


F = 125.2 kN
m
004
OK

P = 692 bar
m
OK
min.


BATTERY
= 125.2 kN
F
m
= 102.3 kN
= 692 bar P
m
= 565 bar
max.
BATTERY BATTERY
BATTERY 
BATTERY
LED
ON
LED
OFF
RESET
SW:S1J41413
LED
OFF
3 SEC.
LED
ON
= 125.2 kN
OK
= 692 bar
OK
min.



30001

