Risk Of Electric Shock - Toshiba TOSVERT VF-S15 Schnellstartanleitung

1. General 1. General
WARNING / AVERTISSEMENT WARNING / AVERTISSEMENT

- RISK OF ELECTRIC SHOCK -

- RISK OF ELECTRIC SHOCK -
DANGEROUS VOLTAGE MAY EXIST FOR _15_MINUTES AFTER DANGEROUS VOLTAGE MAY EXIST FOR _15_MINUTES AFTER
REMOVING POWER REMOVING POWER
- RISQUE DU CHOC ÉLECTRIQUE - - RISQUE DU CHOC ÉLECTRIQUE -
UNE TENSIONDANGEREUSE PEUT ÊTRE PRÉSENTÉE JUSQU'À UNE TENSIONDANGEREUSE PEUT ÊTRE PRÉSENTÉE JUSQU'À
_15_ MINUTES APRÈS AVOIR COUPÉL'ALIMENTATION _15_ MINUTES APRÈS AVOIR COUPÉL'ALIMENTATION
The following steps must be performed before wiring and servicing. The following steps must be performed before wiring and servicing.
(1)Turn off all input power. (1)Turn off all input power.
(2)Wait at least fifteen minutes and check to make sure that the charge lamp is no longer lit. (2)Wait at least fifteen minutes and check to make sure that the charge lamp is no longer lit.
(3)Use a tester that can measure DC voltage (800VDC or more), and check to make sure that the voltage to the DC main (3)Use a tester that can measure DC voltage (800VDC or more), and check to make sure that the voltage to the DC main
circuits (across PA/+ and PC/-) is 45V or less. circuits (across PA/+ and PC/-) is 45V or less.
If these steps are not properly performed, the wiring will cause electric shock. If these steps are not properly performed, the wiring will cause electric shock.
2. Compliance with Installation 2. Compliance with Installation
A UL certificate was granted on the assumption that the inverter would be installed in an enclosure. Therefore, install the A UL certificate was granted on the assumption that the inverter would be installed in an enclosure. Therefore, install the
inverter in an enclosure and if necessary, take measures to maintain the inverter ambient temperature (temperature in the inverter in an enclosure and if necessary, take measures to maintain the inverter ambient temperature (temperature in the
enclosure) within the specified temperature range. enclosure) within the specified temperature range.
Be sure to apply the minimum enclosure size shown in the remark under Table 3 and Table 4 Be sure to apply the minimum enclosure size shown in the remark under Table 3 and Table 4
Standard installation Standard installation
3 cm or more 3 cm or more
Environments Environments
Location of use Location of use
Elevation Elevation
Ambient temperature Ambient temperature
Storage temperature Storage temperature
Relative humidity Relative humidity
Pollution degree Pollution degree
5 cm or more 5 cm or more
VF-S15 VF-S15
3 cm or more 3 cm or more
5 cm or more 5 cm or more
Indoors; not exposed to direct sunlight, corrosive gas, explosive gas, flammable gas, Indoors; not exposed to direct sunlight, corrosive gas, explosive gas, flammable gas,
oil mist, or dust; and vibration of less than 5.9m/s oil mist, or dust; and vibration of less than 5.9m/s
1000 m or less 1000 m or less
-10 to +40°C (50°C) -10 to +40°C (50°C)
Maximum Surrounding Air Temperature Maximum Surrounding Air Temperature
40 °C (with the protective label on the top of the inverter) 40 °C (with the protective label on the top of the inverter)
50 °C (without the protective label on the top of the inverter, 50 °C (without the protective label on the top of the inverter,
except 0.75 kW or less in 200/240 V class) except 0.75 kW or less in 200/240 V class)
-25 to +70°C (Temperature applicable for a short term.) -25 to +70°C (Temperature applicable for a short term.)
5 to 95% (free from condensation and vapor). 5 to 95% (free from condensation and vapor).
2 2
2 2
(10 to 55Hz). (10 to 55Hz).
37
2 2
E6582383 E6582383
E6582383