Installing The Appliance - Privileg AG820B8Q-S0EE Gebrauchsanleitung

Page EN-34 Start-up
Installation materials
(18)
(20)
No. Name
(18) Anti-tip feature
(19) Short screws
(20) Long screws
(21) Blind plugs

Installing the appliance

1. Measure the width to find the centre of the
installation cupboard.
2. Mark the centre of the installation cupboard
with a pencil.
(19)
(21)
Quantity
1
2
1
1
3. Position the attached drilling template as
follows:
The front edge of the installation cupboard
and the contact edge of the template must
be flush.
The centre line of the template must be in
line with the centre marking in the installa-
tion cupboard.
4. Transfer the drill holes for the anti-tip fea-
ture (18) from the template to the floor of the
built-in cupboard.
5. Pre-drill the holes for the two screws with
a 3 mm drill.
6. Screw the anti-tip feature (18) in tight with
the two screws (19).
7. Insert the mains plug into a properly instal-
led socket.
8. Push the appliance into the installation
compartment until the front panel meets
the frame of the installation compartment.
(19)