Herunterladen Inhalt Inhalt Diese Seite drucken

Operation; Transport; Storage; Care And Maintenance - Kärcher WV 4-4 Plus Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1

Operation

Starting operation
1. Turn the spray nozzle to "ON".
Illustration M
2. Operate the spray lever several times and spray the
detergent evenly onto the surface to be cleaned
from a distance of approx. 20 cm.
3. Loosen the dirt with the microfibre wipe cover.
Illustration N
4. Press the ON / OFF button to switch the device on.
Illustration O
The charge indicator shows the current charging
state of the battery pack, see chapter Charge indi-
cator.
5. Pull the squeegee blade over the surface to be
cleaned to suck up the waste water.
Illustration P
ATTENTION
Work with the device only until the MAX marking on the
waste water tank is reached. Switch off the device and
empty the waste water tank, see chapter on Emptying
the waste water tank.
Observe the following points to prevent streaks appear-
ing:
● Do not press the squeegee blade too hard against
the surface to be cleaned, just glide over it.
● Hold the device at the correct angle to the surface to
be vacuumed. The distance between the lower end
of the device and the surface should be
approx. 10 cm.
● Use only KÄRCHER detergents, as these are spe-
cially designed for the device.
● Spray a sufficient amount of detergent on the sur-
face so that the surface is not too dry.
● Clean the squeegee blade regularly, see chapter
Clean the squeegee blade and suction nozzle.
● If worn, the squeegee blade must be replaced, see
chapter Clean the squeegee blade and suction noz-
zle.
● Do not clean in direct sunlight or when it is too hot or
cold.
Interrupting operation
1. Press the ON / OFF button to switch off the device.
Illustration Q
2. Place the device on a level surface.
Emptying the waste water tank
Empty the waste water tank as soon as it is filled up to
the MAX marking.
Illustration R
1. Press the ON / OFF button to switch off the device.
Illustration Q
2. Remove the waste water tank.
Illustration S
3. Drain the waste water tank and rinse it with clean
water.
Illustration T
4. Fit the empty waste water tank into the device.
Illustration U
Ending operation
1. Press the ON / OFF button to switch off the device.
Illustration Q
2. Clean the waste water tank, see chapter Cleaning
the waste water tank.
14
3. Remove the battery pack, see chapter Removing
the battery pack.
4. Clean the microfibre wipe cover, see chapter Clean
the microfibre wipe cover.
5. Clean the squeegee blade and the suction nozzle,
see chapter Clean the squeegee blade and suction
nozzle.
6. Allow the device to dry.
7. Assemble the device.
8. Charge the battery pack, see operating instructions
with safety instructions for the battery pack and the
charger.
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during transporta-
tion.
1. Remove the battery pack, see chapter Removing
the battery pack.
2. Secure the device against slipping and tipping over
when transporting in vehicles.
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during storage.
ATTENTION
Danger of frost
Incompletely emptied devices can be destroyed by
frost.
Completely empty the device and accessories.
Protect the device from frost.
1. Remove the battery pack, see chapter Removing
the battery pack and store it properly, see the oper-
ating instructions for the battery pack.
2. Store the cleaned device upright in a clean, dry
place, protected from frost and dust.
Illustration V

Care and maintenance

WARNING
Improper cleaning
Risk of injury from electric shock, risk of fire, risk of dam-
age
Turn off the device and remove the battery pack before
cleaning the device.
Do not immerse the device in liquids.
Never clean the device under running water.
Cleaning the waste water tank
1. Empty the waste water tank, see chapter Emptying
the waste water tank.
2. Remove the waste water tank lock.
Illustration W
3. Clean the waste water tank and lock by hand.
Illustration X
Clean the microfibre wipe cover
1. Remove the microfibre wipe cover from the wiping
attachment or adapter.
Illustration Y
2. Wash the microfibre wipe cover under running wa-
ter.
English

Transport

Storage

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis