HIKOKI G 3612DVE Bedienungsanleitung Seite 12

English
REGARDING LITHIUM-ION BATTERY
TRANSPORTATION
When transporting a lithium-ion battery, please observe the
following precautions.
WARNING
Notify the transporting company that a package contains a
lithium-ion battery, inform the company of its power output
and follow the instructions of the transportation company
when arranging transport.
○ Lithium-ion batteries that exceed a power output of
100 Wh are considered to be in the freight classifi cation
of Dangerous Goods and will require special application
procedures.
○ For transportation abroad, you must comply with
international law and the rules and regulations of the
destination country.
Power Output
2 to 3 digit number
USB DEVICE CONNECTION
PRECAUTIONS (UC18YSL3)
When an unexpected problem occurs, the data in a USB
device connected to this product may be corrupted or lost.
Always make sure to back up any data contained in the USB
device prior to use with this product.
Please be aware that our company accepts absolutely no
responsibility for any data stored in a USB device that is
corrupted or lost, nor for any damage that may occur to a
connected device.
WARNING
○ Prior to use, check the connecting USB cable for any
defect or damage.
Using a defective or damaged USB cable can cause
smoke emission or ignition.
○ When the product is not being used, cover the USB port
with the rubber cover.
Buildup of dust etc. in the USB port can cause smoke
emission or ignition.
NOTE
○ There may be an occasional pause during USB
recharging.
○ When a USB device is not being charged, remove the
USB device from the charger.
Failure to do so may not only reduce the battery life
of a USB device, but may also result in unexpected
accidents.
○ It may not be possible to charge some USB devices,
depending on the type of device.
NAMES OF PARTS (Fig. 1–Fig. 20)
Motor
Nameplate
Push button
Side handle
Gear cover
Depressed center
wheel (sold separately)
Toolless wheel guard
LED light
12
Switch
Housing
Switch panel
Filter
Battery
Auto mode switch
Lighting mode switch
Lighting mode
indicator lamp
Switch lever
Dial
Guard clip (mounted
on wheel guard when
packaged)
Latch
Charge indicator lamp
Tabs of guard clip
(2 locations)
Lever
Bump of wheel guard
SYMBOLS
WARNING
The following show symbols used for the machine. Be
sure that you understand their meaning before use.
G3612DVE / G3613DE / G3613DF / G3613DVE /
G3613DVF / G3615DVE / G3615DVF:
Cordless Disc Grinder
To reduce the risk of injury, user must read
instruction manual.
Always wear eye protection.
Always operate the power tool with two hands
Not for cut-off operations
When using a cutting-off wheel, be sure to
attach the type A wheel guard.
when using a type B wheel guard for cutting-off
operations with bonded cut-off wheels, there is
an increased risk of exposure to emitted sparks
and particles, as well as exposure to wheel
fragments in the event of a wheel burst.
Notch of body
Hole of wheel guard
Bump of lever
Wheel washer (C)
Wheel nut
Wrench
Abrasive cutting
wheel
(sold separately)
Diamond wheel
(sold separately)
Off -lock lever
Remaining battery
indicator switch
Remaining battery
indicator lamp
Mesh
Soft brush
Diamond cup wheel
(sold separately)
Dust collection adapter
(For diamond cup
wheel)
(sold separately)
Dust collection adapter
(For diamond wheel)
(sold separately)