GOK FL 90-4 Montage- Und Bedienungsanleitung Seite 19

Risk of explosion if gas installation work is not carried out professionally!
Improper installation, adjustment, modifications, operation or maintenance can cause
injury or damage to property.
Observe the applicable national installation regulations for LPG systems.
Risk of asphyxiation from gas leaks in enclosed spaces.
High concentrations of gas can cause difficulty in breathing and lead to unconsciousness.
A discharge line
Screw connections
If connections leak, there is a danger of explosion, fire or suffocation!
Gas may escape if the product is turned.
Do not turn the product after it has been installed and the connections have been
tightened.
Tighten connections only when they are not pressurised.
Risk of injuries due to blown-out metal chips!
Metal chips may cause eye injuries.
Wear safety goggles!
Assembly notes
Malfunctions caused by residues! Proper functioning is not guaranteed.
• Visually check that there are no metal chips or other residues in the connections!
• It is important that metal chips or other residues are blown out!
Install with suitable tools, if required.
Regarding screw connections, use a second spanner to brace against the connection
nozzle. Do not use unsuitable tools, such as pliers.
Install the pressure regulator so that it is not under tension.
Use the regulator support.
Product damaged through incorrect installation direction
Proper functioning is not guaranteed.
• Observe the installation direction (marked on the product with an arrow
To install the connections, see CONNECTIONS in the assembly manual.
The gaskets at the inlet connections (if provided) must be replaced when re-assembling!
Make sure that the gaskets sit properly in the mounting and that the screws are tightened.
For outdoor applications, the product must be located or protected so that no dripping
water can enter. We recommend installation in under a hood or in a gas pressure regulator
box, respectively, or in a housing.
We recommend that you install the pressure regulator at an angle to the breather. This
allows condensation to flow away better.
Observe the evaporation capacity of gas cylinders and gas tanks.
• Temperature change of the gas.
• The cylinder/gas tank pressure falls below the required inlet pressure of the operating
regulator.
• Proper operation of the LPG system is no longer guaranteed.
Artikel-Nr. 05 004 50 i
Low pressure regulator Type FL 90-4, Type FL 91-4
must be connected from the breather on the product to outdoors.
).
19 / 36