Installation Instructions - Monsher MHI 3001 Bedienungsanweisung

44

6. INSTALLATION INSTRUCTIONS

; Theappliance must be installed and connected in accordance with current
regulations.
; After unpacking the appliance, ensure there is no visible damage. If it has been
damaged during transit, DONOTUSE, contact where you buy immediately.
; Selection of installation equipment
; Cut out the work surface according to the sizes shown in the drawing.
; For the purpose of installation and use, a minimum of 5 cm space shall be preserved
around the hole.
; Be sure the thickness of the work surface is at least 30mm. Please select heat-
resistant work surface material to avoid larger deformation caused by the heat
radiation from the hotplate. As shown below (measure by unit: mm):
L (mm)
W (mm)
520 288
Note: The safety distance between
the hotplate and the cupboard above the
hotplate should be at least 760mm.
H (mm) D (mm)
56 52
Under any circumstances, make sure
the electric hob is well ventilated and
the air inlet and outlet are not blocked.
Ensure the electric hob is in good work
state. As shown below:
A (mm) B (mm)
265 +5 490 +5
-0 -0
English
X (mm)
50 min