Monsher MHI 3001 Bedienungsanweisung Seite 43

English
Some buttons do not
work, or LED display is not
normal
The Cooking mode
indicator comes on, but
heating is not started
During the operation, the
heating stops suddenly
and the display flashes "U"
"U" is displayed in the
heating area on the same
side (such as the first and
second areas)
Fan motor sounds
abnormal
The above is the common fault judgment and inspection.
Please do not disassemble the equipment by yourself, so as to avoid any danger and damage to the induction cooker.
Please note!
The following shall not be considered as defects of the Product
Sound of working of induction cooking zones at activation of increased
power
Induction and
Dark, visually non-luminous segment of the thermostat on a glass ceramic
electric cooktops
cooking zone
Discoloration of desktop surface when using the product
The display board is damaged
High temperature of the hob
Something wrong with the fan
Power board damaged
Wrong pot type
The diameter of the bottom of the pot
is too small
Pot overheated
Power board and display
connection failure
The communication part of the display
board is damaged
Power board damaged
The fan motor is damaged
Replace the display board
The ambient temperature may be too high
and the air inlet or vent may be blocked
Check whether the fan operates normally. If
not, replace the fan.
Replace the power board
suitable pan (refer to the manual);
Pot detection circuit damage, replace the
power board.
Wait for the temperature to return to normal;
Press the "on / off" button to restart the
device
board Check the connection
Replace the display board
Replace the power board
Replace fan
43 43