Operation Instructions - Monsher MHI 3001 Bedienungsanweisung

36
English

3. OPERATION INSTRUCTIONS

3.1. TURN ON
Press "ON/OFF" button to switch on or switch off the hob and you will hear a "beep"
after touch. All display will show "-" or "- -" respectively. If without any operation after
switch on the hob in 60 seconds, the hob will be turned off automatically.
Use e a suitable pot/pan on the heating area.
Make sure the bottom of the pan/pot and the surface of the heating area are clean
and dry
When touch the heating zone selection button, display nearby will flash «0».
The display will stop flashing within 5 seconds after no operation, and show the power
level.
Control the power by "+"/"-" or slider touch control.
When the heating power of any heating zone is «0», the cooker will automatically enter
the standby state after 1 minute of no operation.
You can change the power at any time during cooking.
3.2. TURN OFF
Touch the selection button of the heating area that you want to close, and the digital
display nearby will flash the current power level.
Turn off the heating zone by sliding down to «0» or touch the «-» and «+» keys at the
same time.
Press the "ON/OFF" button to switch on or switch off the cooker.
Take care of the residual heat of crystal plate.
«H» means which heating zone is hot. When the surface cools to a safe temperature,it
will disappear. It can also be used as an energy saving function. If you want to further
heat the pot, use the heating zone with residual heat.