Disposal - Balluff BCW F03EA-Serie Betriebsanleitung

Self-adhesive Capacitive Sensor Head BCW F03EA...
Display Configuration
Set operating mode (switching or
8888
5oA
analog)
Key : Parameter setting mode (flashing)
5. Use keys or
operating mode A .
Display Configuration
Switching mode (output function:
5
on/off)
Analog mode (output function:
A
4 ... 20 mA or 0 ... 10 V)
6. Confirm by pressing
Display Configuration
Submenu: Configuration
8
( )conf
7. Confirm by pressing
8. Use keys to select
Display Configuration
Setting analog output
88888
5A
Key : Parameter setting mode (flashing)
9. Select output interface
(Key or
Display Configuration
Setting as voltage output
IOU
(0 ... 10 V)
Setting as current output
2ONA
(4 ... 20 mA)
10. Confirm by pressing
11. Use keys to select
Display Configuration
Teach mode
BI
tA
12. Confirm by pressing
Key : Parameter setting mode (flashing)
8 english
to select analog
key.
key.
or .
).
key.
or .
key.
Bring level to the lowest measurement
value:
►
Use keys to select
Display Configuration
Teach-in
SALo
►
Confirm by pressing
Bring level to the highest measurement
value:
1. Use keys to select
2. Confirm by pressing
3. Exit menu using END.
NOTE
After 10 min. of inactivity the teach menu is
exited without saving your settings.
4. Exit menu using END to save your values.
NOTE
The digital display shows the sensor value. This
unscaled value is not identical to the level height
in cm.
10

Disposal

Disposal of sensor head (BCW) and sensor amp-
lifier (BAE):
►
Follow national regulations for disposal.
or SALo .
key.
or SAHi .
key.