Troubleshooting - Scheppach BGT2800 Original Bedienungsanleitung

You can obtain information on collection
points for waste equipment from your mu-
nicipal administration, public waste disposal
authority, an authorised body for the dispos-
al of waste electrical and electronic equip-
ment or your waste disposal company.

15. Troubleshooting

The table below contains a list of error symptoms and explains what you can do to solve the problem
if your tool fails to work properly. If the problem persists after working through the list, please contact
your nearest service workshop.
Fault
Engine will not start
Engine is running loud-
ly/irregularly
No electrical output
Engine will not switch
off
30 | GB
Cause
No fuel in the tank.
Fuel valve closed.
Air filter dirty.
Engine switch is set to "OFF". Set the engine switch to "ON".
Recoil starter defective.
No engine oil.
Spark plug dirty.
Engine oil level too low (oil
warning lamp is flashing).
On/off switch for motor opera-
tion set incorrectly.
Spark plug dirty
Air filter severely dirty
Fuel contaminated/stale
Choke lever set to "CHOKE"
Incorrect fuel - diesel instead
of petrol
Fault in the a.c. power gener-
ator
Ignition switch-off wire defec-
tive
www.scheppach.com
Remedy
Fill the tank up.
Open the fuel valve.
Clean the air filter.
Repair the recoil starter.
Refill the engine oil.
Clean the spark plug
Refill the engine oil.
Set to the correct position
Clean/replace the spark plug.
Clean/replace the air filter.
Drain and replace the fuel.
Set the choke lever to "RUN"
Drain the fuel and fill with the correct
fuel
For service under warranty, inform
your representative
Close the fuel valve and wait until the
engine shuts off; call customer service