Disposal And Recycling - Scheppach BGT2800 Original Bedienungsanleitung

6 Screw the spark plug in and tighten with
the spark plug spanner.
7 Place the spark plug connector on the
spark plug
When replacing, ensure that no dirt gets
into the cylinder head.
Check the fit of the spark plug.
A loose spark plug can cause damage to
the engine by overheating.
Pulling too hard can damage the thread in
the cylinder head.
The manufacturer is not responsible for
the resulting damages; the user solely
bears the risk. Only use the recommend-
ed spark plugs or identical spark plugs.
Clean the air filter (Fig. 9 + 10)
1 Loosen the locking (b)
2 Remove the filter cover (17)
3 Clean the foam pre-filter (c) in a
non-flammable solvent.
Attention: Do not use petrol or cleaning
solvents with a low flash point to clean
the air filter element. This could result
in fire or explosion.
4 Squeeze the pre-filter in order to remove
the solvent/soapy water.
5 Clean the paper filter by tapping it.
6 Rinse the washed filter element with
clean water.
7 Allow the filter element to dry or blow it
dry with compressed air.
8 Close the filter cover again and secure it
by using the locking.
If the engine is operated in very dusty en-
vironments, clean the air filter daily or after
every ten operating hours.
Never run the engine without an air filter or
with a damaged air filter. This would allow
dirt into the engine, which would result in
severe damage to the engine.
The manufacturer is not responsible for the
resulting damages; the user solely bears
the risk.
Important note in case of repair:
When returning the generator for repair, for
safety reasons, ensure that it is free of oil
and petrol when it is sent to the service
centre.
Service information
Please note that the following parts of this
product are subject to normal or natural
wear and that the following parts are there-
fore also required for use as consumables.
Wear parts*: spark plug
* Not necessarily included in the scope of
delivery!

14. Disposal and recycling

The equipment is supplied in pack-
aging to prevent it from being dam-
aged in transit. The raw materials in
this packaging can be reused or re-
cycled. The equipment and its ac-
cessories are made of various types
of material, such as metal and plastic. De-
fective components must be disposed of as
special waste. Ask your dealer or your local
council.
Old devices must not be disposed of
with household waste!
This symbol indicates that this product
must not be disposed of together with
domestic waste in compliance with
the Directive (2012/19/EU) pertaining
to waste electrical and electronic equipment
(WEEE). This product must be disposed of
at a designated collection point. This can
occur, for example, by handing it in at an
authorised collecting point for the recycling
of waste electrical and electronic equip-
ment. Improper handling of waste equip-
ment may have negative consequences for
the environment and human health due to
potentially hazardous substances that are
often contained in electrical and electronic
equipment. By properly disposing of this
product, you are also contributing to the ef-
fective use of natural resources.
www.scheppach.com
GB | 29