Troubleshooting - Royal Dirt Devil EQU Bedienungsanleitung

5 Troubleshooting

5 Troubleshooting
First check according to the following table if you can solve the problem on your own before
contacting your authorised Royal
WARNING:
Danger of injury! Never use a defective appliance. Always switch off the appliance and disconnect
it from the mains before starting troubleshooting
power cord".
Problem
The appliance will The plug is not connected to the
not start mains or the appliance is not
switched on.
Socket does not carry current.
The power cord is damaged.
Red warning light The dust filter bag is full or
is on. clogged.
Nozzle, telescopic tube or suction
hose are clogged.
The power setting does not fit the
flooring.
The filter is dirty.
Cleaning is The attached nozzle does not fit
unsatisfactory in the flooring.
spite of the
The "carpet/hard floor" switch
appliance working
(Fig. 1/9) is in the wrong position
correctly.
for the particular type of floor.
The appliance Sucked-in objects are obstructing
makes unusual the air stream.
noises.
NOTE:
If you cannot solve the problem by following these instructions, please refer to your authorised
®
Royal dealer, Royal
196, "Royal Appliance Int. GmbH International Service").
®
dealer, Royal
Possible cause
service partner, your appliance market or Royal customer service ( Page
®
service partner or appliance market.
Chapter 3.3, "Switching off and retracting
Insert the plug into a mains socket and
switch on the appliance
"Vacuum cleaning".
Test the cylinder vacuum cleaner on another
socket that you are sure is carrying current.
Have the power cord replaced by the
®
Royal Appliance Customer Service,
address: Page 35, "Warranty".
Empty/clean the dust filter bag.
Remove the obstacle. If necessary, use a
long wooden stick (e.g. a broomstick) to do
this.
Set the power to the setting suggested for
the flooring, Chapter 3.1, "Vacuum
cleaning", step 4.
Change/clean the respective filter
4.4, "Changing the motor protection filter" or
Chapter 4.3, "Changing the hygienic
exhaust filter".
Attach the correct nozzle
"Using further nozzles (accessories)".
Set the "carpet/hard floor" switch (Fig. 1/9)
to the correct position for the type of floor,
Chapter 3.1, "Vacuum cleaning", step 5.
Remove the objects. If necessary, use a
long wooden stick (e.g. a broomstick) to do
this.
Solution
Chapter 3.1,
Chapter
Chapter 2.3,
33