Atag DX6411F Bedienungsanleitung Seite 195

INSTALLATION AND CONNECTION
Note
When the power is connected, the electronics of the oven are
initialised; this neutralizes the lighting for a few seconds. The electric
cable (H05 RR-F or H05 VV-F, Min. 1.5 m, 1.5~2.5 mm²) must be long
enough for it to be connected to the built-in oven standing on the floor
in front of its unit.
Open the back cover of the oven at the bottom (using a flat-bladed
screwdriver) and completely unscrew the connection screw and
the cable clamp before fitting conducting wires into the appropriate
terminals.
• The earth wire must be connected to the (
• If the oven is connected to the power supply by a plug, this must
remain accessible once the oven has been fitted.
• We cannot accept any liability in the event of an accident resulting
from non-existent or faulty earthing.
) terminal of the oven.
EN 17