Controls And Functions - Klarstein LAS PILAS Bedienungsanleitung

CONTROLS AND FUNCTIONS

Panel controls
Key Action/function
1. Press this button once to switch on the
fl ame effect, the fuel bed is illuminated and
the control panel and remote control are
activated.
2. Press this button again to switch off the
fl ame effect and deactivate the remote
control and all functions.
The brightness of the fl ame effect can be
regulated with the dimmer. Press the button
several times to adjust the fl ame effect as
desired.
To use the heating function, the fl ame effect
must be activated.
1. The unit has 12 temperature settings
from 18 °C - 30 °C.
2. Press and hold this button for 3 seconds
to switch from Celsius to Fahrenheit.
Press the timer key several times to select
the desired timer setting (1 H, ...; 8 H, Off).
Display/result
1. The fl ame effect and the fuel bed are
switched on. The control panel and the remote
control can be used.
2. The fl ame effect and the indicator light
are switched off. The control panel and the
remote control cannot be used.
The different stages of the fl ame effect will be
cycled through and will then start again from
the fi rst stage.
1. Set the desired temperature with the
thermostat. After switching off the unit, the
heater may continue to emit air to cool itself
down.
EN
27