Functions And Settings - Klarstein Basel Illumine Bedienungsanleitung

FUNCTIONS AND SETTINGS

Automatic heating
• Press [IC] button on the remote controller to start or exit the automatic heating.
• When turned on, the fireplace can automatically change the heating mode
depending on the set temperature and the room temperature.
• During a timed starting process, it is possible to start heating ahead of schedule.
Setting the day and time
1. Settings are done on the remote controller.
2. Press [DATE/TIME] button. Then press  or  button to select the day.
3. Press [DATE/TIME] button again. Then press [+] or [-] button to set the hour.
4. Press [DATE/TIME] button again. Then press [+] or [-] button to set the minute.
5. Press [OK] button to complete.
Temperature setting
• The default set temperature is 20 °C.
• Press [+] or [-] button on the remote control to set the temperature, which ranges
from 15 to 30 °C.
• This setting is only for the temperature in the normally mode, not for the temperature
in the timer mode.
Note: The set temperature must be higher than the room temperature for the heater to
work.
Safety cut-off
• This appliance is fitted with a safety cut-off which will operate if the fireplace
overheats (e.g. due to blocked air vents).
• For safety reasons, the fireplace will NOT automatically reset.
• To reset the appliance, disconnect the appliance from the mains supply for at least
15 minutes.
• Reconnect to the mains supply and switch on the appliance.
EN
27