Buttons And Functions - Klarstein Zermatt Handbuch

EN
20
Magnetic Holder for the Remote Control
On the right side of the electric fireplace there
is a magnet to which you can easily attach the
remote control.

BUTTONS AND FUNCTIONS

O/I Switch
Press the [O/I] switch so that it is in the "I" position. The appliance is switched on.
If you set the [O/I] switch to the "O" position, the power is turned off completely. All
functions are stopped, even when other buttons are in the ON position.
Switch Appliance On/Off
Press this button to turn ON the fireplace. The appliance will beep.
Press again to turn off the fireplace and the fan will continue to work
for 30 seconds without heat. The heater is preset to start with high heat
(1800 W) and the highest flame intensity.
Activate Flame Effect
Press this button once for the flame effect. The appliance will beep.
Press again to increase the flame intensity. There are six light intensities to
choose from. The flame optics will go lower under the sequence of 6, 5, 4,
3 ,2 and 1. Press the button again to stop the flame effect.
Select Heating Level
900 W: Press this button for low heat level. The indicator light will be ON. The
heater will provide low heat level. Press once again to stop the low heat
level function.