Functions And Settings - Klarstein 10031572 Bedienungsanleitung

EN
22

FUNCTIONS AND SETTINGS

Main switch (A)
Open the cover on the bottom of the unit and press button A down to the ON position.
On / Off button
Press the on / off button to start the flame effect. The following will appear on the
display:
• The heating symbol will be displayed and the appliance will
start to heat if the room temperature is below the standard
setting (10 ° C). If the temperature is higher than 10 ° C, the
icon will not be displayed and the unit will not heat up.
• The clock symbol will flash to indicate that no timer has
yet been set. Follow the steps described in the „Operating
Modes" section under „Timer Mode" to set the timer.
When the unit is switched on, two short beeps will sound, increasing in tone. When it is
switched off, three beeps will sound, which will decrease in tone. When switching on,
the heating level, the setpoint temperature and the clock symbol will be displayed. The
display disappears after 60 seconds unless you press a key. Press any key to return to
the display.
Key lock
Press and hold the OK button for more than 6 seconds to lock or
unlock the keys. As soon as the keys are locked, [LOC] flashes
on the display for 6 seconds and then disappears. Press any key
and [LOC] will flash again. Press the OK button for 6 seconds to
unlock the keys.
Note: The On / Off button (B) is never locked.