steute RF UBR SW868-NET AC 4S Montage- Und Anschlussanleitung Seite 4

RF UBR SW868/SW915/SW917/SW922-NET AC/DC 4S/2S
//
Montage- und Anschlussanleitung / Funk-Aktor
Mounting and wiring instructions / Wireless actor
Instructions de montage et de câblage / Actuateur sans fil
Istruzioni di montaggio e collegamento / Attuatore wireless
Instruções de montagem e instalação / Atuador sem fio
Инструкция по монтажу и подключению / Радио-привод
English
Penetration of radio signals:
Material
wood, gypsum, glas uncoated
brick stone, press boards
armoured concrete
metal, aluminium lamination, water
Typical ranges:
Location
in free field (SW868/915/917)
in free field (SW922)
indoors (SW868/915/917)
indoors (SW922)
Safety
Do not use the device in connection with other devices whose direct
or indirect purpose is to ensure life or health, or whose operation may
pose a threat to humans, animals or material assets. The described
products were developed in order to assume functions as part of an
entire plant or machine. It is the responsibility of the manufacturer of
a plant or machine to guarantee the correct general function.
ESD
Ensure adequate ESD protection for all work that requires opening
the unit.
Start-up and operation mode
Requirements:
- Connect cable for supply voltage.
- Pay attention to contact names and circuit diagrams.
- The LED shows the operating states. If the wireless actor and the
LED are both switched on, then the device is ready for use.
Switching of relays
Switch relays: The relays are switched via the Sensor Bridge. They are
switched manually via the user interface of the Sensor Bridge under
»Sensors & Actors« or via an external interface, e.g. REST API (see
www.nexy.net/docs). The actors have two modes, »Instant« and »Eco«.
In the pre-set Instant mode the relays are switched directly. In the Eco
mode the relays are always switched during the wake-up time of the
RF UBR SW868/915/917/922-NET.
Set wake-up time: The wake-up signal is adjustable (configurable on
the Sensor Bridge interface under: »Groups«, »Timing«).
For example: »0x01« for relays switching once a minute.
Operation mode
Operational, not taught in
Operational, taught in
Penetration
Push-button actuated, telegram sent
90...100 %
N.B.
65...95 %
Subject to technical modifications. Reconstruction and alterations to
10...90 %
the device are not allowed.
0...10 %
Cleaning
Wireless range (approx.)
450 m
150 m
Clean enclosure on the outside only. Clean enclosure with household
40 m
cleaning agents. Do not use any compressed air to clean.
20 m
Maintenance and repair
We recommend regular maintenance as follows:
1. Remove all dirt particles.
2. Replace damaged parts.
3. Test the function.
Disposal
- Observe national, local and legal regulations concerning disposal.
- Recycle each material separately.
4 / 28
=
DANGER
Live parts. Electric shock hazard! When cleaning:
observe IP degree of protection.
=
DANGER
Live parts. Electric shock hazard! Do not repair
defective or damaged devices. Replace them.
Alternative: Repair of defective device by trained
personnel in agreement with steute and with steute
spare parts.
=
DANGER
Live parts. Electric shock hazard! Risk of burns!
Do not rebuild or modify the device in any way.
=
DANGER
Live parts. Electric shock hazard! Open device only
while it is in zero potential state.
LED
lights up red
lights up green
flashes orange