Electrical Connection; Behaviour In The Event Of An Emergency; Intended Use - Kärcher IVM 60/24-2 M ACD WS Bedienungsanleitung

ble for sucking up ignition sources and
dusts with a glow temperature ≤ 190 °C.
● Every time before use, check whether the
equipotential bonding conductors (earthing
conductors) are connected. ● The device
must not be used or stored outdoors in wet
conditions. ● Apply the parking brake at the
steering roller to ensure a secure footing for
the device. The device may move uncon-
trollably if the parking brake is open. ● Fill
the liquid container only with the liquids rec-
ommended by the manufacturer.
CAUTION ● In case of longer breaks in
operation and after use, switch off the de-
vice at the power switches and unplug the
mains plug.
ATTENTION ● Only use the device in-
doors. ● Risk of crushing! Wear gloves
when removing or installing the suction
head, filter inlay or collection container.
● Risk of damage! Never vacuum without a
filter or with a damaged filter. ● Wear safety
shoes when operating the device. ● Only
move the device at walking speed, and to
move down a decline, have two workers
steady the device as necessary. ● Be care-
ful to ensure that there is no dust spillage
when replacing accessories. ● Surface
temperatures can rise to 135° C during nor-
mal operation. ● Avoid kinking the suction
hose unit. ● Carry out a regular visual in-
spection of the hoses. ● Take appropriate
precautions for removal, handling, storage
and disposal of the sludge, such as mixing
with inert liquids according to local regula-
tions. ● Hydrogen gas is flammable and
can be produced by extracting up certain
materials such as aluminium, magnesium,
etc. The valve prevents the accumulation of
hydrogen gas inside the liquid container.
Clean and inspect the valve regularly and
check for signs of damage. ● Ensure ade-
quate ventilation of the installation site to
reduce the hydrogen concentration. ● Emp-
ty the dirt receptacle after each use and
when it is full of sludge to reduce the forma-
tion of hydrogen gas.

Electrical connection

The device may only be connected to an
electrical connection which has been set up
by a qualified electrician as per IEC 60364.
For connected loads see Technical data
and type plate.
DANGER
Danger of electric shock
Danger of death
Avoid damaging the power cables by driv-
ing over them or otherwise crushing them,
or by jerking them.
Protect the cables from heat, oil and sharp
edges.
Check the mains connection of the device
for damage every time before operation.
Do not operate the device using a damaged
cable. Have any damaged cables replaced
by a qualified electrician.
Behaviour in the event of an
DANGER
Risk of injury and damage in the event
of a short-circuit or other electrical
faults
Danger of electric shock, danger of burns
Switch off the device and unplug the mains
plug.
Behaviour in case of filter breakage /
leakage:
1. Switch off the unit immediately.
The unit may not be operated without
the fresh water filter.
2. Replace the filter.

Intended use

The device is intended for:
● Wet and dry cleaning of floor and wall
surfaces
● Extraction of dry, flammable, deposited
dusts hazardous to health; dust class M
according to EN 60335-2-69
● Vacuuming of non-explosive substances
● Vacuuming of flammable dusts of all
dust explosion classes
● Vacuuming of dusts and coarse dirt
● Vacuuming of flammable dusts from a
zone 22 if the device is installed outside
of potentially explosive areas
English
emergency
19