Assigning The Network Settings And Ip Address - Weidmuller AC SMART ECO Bedienungsanleitung

► If no Ethernet cable was installed in the EV charging box during initial
installation, add another cable feed-through in the housing of the EV
charging box and insert a cable gland. Observe the Assembly and installa-
tion instructions.
► Route the Ethernet cable through the cable gland and connect the cable to
Ethernet interface X3 of the control board in the housing cover.
► Close the EV charging box and screw the cover back on.
► Install the design cover if available.
► Switch on the EV charging box.
The next steps:
– Adjust the network settings (assign an IP address), see Chapter 9.2.
– Configure the EV charging box in the web server, see Chapter 9.3.
9.2
Prerequisite The EV charging box must be connected to a local network via LAN cable,
see Chapter 9.1.
► Start your computer.
► Press the Win+R buttons.
The Execute window opens.
► Enter the command ncpa.cpl and confirm by pressing OK.
► Right click on the cabled network connection and click Properties.
Image 9.2 Selecting the network connection
► Click internet protocol, version 4 (TCP/IPv4) and then click Properties.
Image 9.3 Selecting internet protocol
If there is already data in the fields, note the data and settings so that you will
be able to access the network later on.

Assigning the network settings and IP address

Networking and configuring the EV charging box
Operating instructions – AC SMART 85