Networking And Configuring The Ev Charging Box; Connecting The Ev Charging Box With The Local Network - Weidmuller AC SMART ECO Bedienungsanleitung

84 Operating instructions – AC SMART
9 Networking and configuring the EV
charging box
You can integrate a single EV charging box into a local network using an
Ethernet cable, for instance via a switch in the network, or via a central
network router. In addition, you can connect multiple EV charging boxes
together to form a charging network.
Router /
Switch
Router /
Switch
Image 9.1 EV charging box with LAN connection and charging network
The first time the EV charging box is connected to the local network, the
following steps must be carried out:
– Connecting the EV charging box with the local network via Ethernet cable
– Adjusting the network settings (assign an IP address)
– Starting the web server of the EV charging box
– Configuring the EV charging box in the web server
– If desired, connecting the EV charging box to an existing WLAN
9.1 Connecting the EV charging box with the local
network
WARNING!
Risk to life due to electric shock
There is a risk of electric shock when working on the electrical installation of
the product.
► Commission a qualified electrician to network the EV charging box.
To integrate the EV charging box into an existing local network, proceed as
follows:
► Ensure that the EV charging box is not connected to a vehicle.
► Ensure that power to the EV charging box is switched off.
► Remove the design cover if available.
► Loosen the screws in the cover of the EV charging box and open the EV
charging box.