Connecting The Ev Charging Box To An External Device (Modbus) - Weidmuller AC SMART ECO Bedienungsanleitung

Resetting the EV charging box to factory settings
All settings and data will be reset to defaults or deleted.
Prerequisite You must be logged in as an Admin. Electrician only!
The EV charging box may not be connected to a vehicle.
You can reset the EV charging box in the web server or via the power supply.
Resetting the EV charging box in the web server
► Click Config/General.
► Click Start.
► Confirm the reset.
Resetting the EV charging box via the power supply
► Switch the residual current protective device on and off ten times within
one minute.
The EV charging box will be reset to default settings and restarted
automatically.
Set digital output
You can freely configure the digital output. The following settings are
available:
– The output is non-functional.
– The output puts out a high signal if a charging process is active (status C).
► Click Config/General.
► Select the desired setting.
► Click Save.
9.4
EV charging boxes in the AC SMART product family can be controlled via
Modbus RTU or Modbus TCP via an external management system. The
external management system is the client. The EV charging boxes are con-
figured as servers upon delivery. There may be only one client, but multiple
servers. The Modbus TCP interface can be used by LAN and WLAN.
► Commission an electrician.
► Observe the Assembly and installation instructions.
Connecting the EV charging box to an external
device (Modbus)
Networking and configuring the EV charging box
Operating instructions – AC SMART 93