Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operation
Before getting started
•
Read the "Safety" chapter from page EN-4.
•
Set up and connect the appliance as
described in chapter "Start-up" from
page EN-25.
Switching the appliance on
and off
NOTICE
Risk of damage!
If the cooling appliance has been trans-
ported horizontally, lubricant from the
compressor may get into the cooling
circuit.
■ Allow the appliance to stand upright
for approx. 2 hours after transport
and before connecting.
Switching on
•
To switch the appliance on, insert the
mains plug into the socket.
The compressor starts to work, the refrig-
erant flows through the pipes and a quiet
humming sound can be heard.
If the appliance is making unusual
noises, check that it is stable and re-
move any objects that may be on top
of it.
Switching off
•
To switch the appliance off, pull the mains
plug out of the socket.
If the appliance is switched off, leave
the doors open slightly to avoid mould
formation.
Operation
Setting the temperature
CAUTION
Health hazard!
The appliance may not operate proper-
ly if exposed to low ambient tempera-
tures for extended periods of time. The
temperature may increase in the fridge
and freezer which may cause the foods
stored within to spoil more quickly.
■ Always ensure the prescribed ambi-
ent temperature is maintained (see
"Intended use" on page EN-4).
If you set a lower temperature, you will
require greater refrigeration perfor-
mance. This increases energy con-
sumption.
Setting the temperature in the
fridge
1
2
3
•
To set the temperature, use the tempera-
ture controller (1).
If the temperature controller is set to
"0", the comperssor will stop working
and the light will turn off.
Page EN-11
0
(1)
Werbung
Inhaltsverzeichnis
