Description Of The Control Panel - Dantherm HCV 4 Bedienungsanleitung

Description of the control panel

Introduction This section provides a detailed description of the HCP4 control panel.
Illustration This illustration shows the control panel, which provides operating information via vari-
ous indicators.
The control panel has three buttons that are easy to activate:
Part/function This table provides a description of the different parts of the control panel:




9

 
Part
Operating indicator
Bypass
(Only HCV 5)
Manual operation
1 2 3 4


Function
The operating indicator can display three different
modes:
• Green: on, OK operation
• Yellow blinking and beeping sound: filter needs to
be changed
• Red light, beeping sound: unit error
Upon activation, the button will light up, and the hot,
damp exhaust air will be led around the exchanger in
order to avoid heating the outside air before it is
blown into the house. This allows the coolest possible
air to enter the house without the use of heat recov-
ery.
The manual bypass function remains active for 6
hours, after which the unit reverts to automatic bypass
mode.
In automatic bypass mode, the bypass module auto-
matically opens and closes in accordance with the fac-
tory settings; read more about this in the installation
guide, under the "Set points and control strategy" sec-
tion.
After activating manual operation, it is possible to
change between shutting down the unit and fan step
1-4.
For a more detailed explanation of the four levels,
consult the "Function description" section on page 6
Indicates the current fan step.

Continued overleaf