Wall Mounting - Klarstein ALINEA 60 SMART Bedienungsanleitung

Conversion of the cooker bonnet into a recirculation bonnet:
• If you want to use the cooker bonnet as a recirculation bonnet, you must fit
the activated charcoal filter(s) to the fan motor before using the bonnet. If
not included in the scope of delivery, you must obtain the activated charcoal
filter(s) from the supplier of your cooker bonnet.

WALL MOUNTING

Power connection
• Do not connect the unit to the mains until it has been properly installed.
• Never install the appliance if the information on the rating plate (V) does not
match your mains voltage. The rating plate is located inside the appliance,
behind the grease filter.
• If the cooker bonnet is equipped with a standard plug, connect it to an easily
accessible standard socket.
• If the appliance is not equipped with a connection plug, a two-pole, standard-
compliant switch with a contact gap of 3 mm must be installed by an
authorised specialist in an easily accessible place.
• When the cooker bonnet is connected to the mains, all indicator lights light up
briefly and the cooker bonnet switches to standby mode (accompanied by a
beep).
Installation with exhaust air (fume cupboard outside):
Note: Failure to fit the screws or fixing device in accordance with these
instructions may result in electrical hazards.
Note: Observe the safety instructions for operating the unit when the air is
discharged to the outside. If the cooker hood is in operation at the same time
as an appliance that draws its energy from a source other than electricity, the
negative pressure in the room must not exceed 4 Pa (4 x 10-5 bar).
EN
31