Before Initial Use; Setting Up And Connecting The Device - Beem CM5020D-GS Bedienungsanleitung

31

Before Initial Use

1. Wipe the device with a clean, damp cloth. Clean all accessories with a little detergent and clear
water.
2. When the device is delivered, the water pipe is fi tted with transport protection that needs to
be removed. Pull the water tank (6) vertically up out of the device. On the water feed on the
device there is an orange plug – pull it out. The water tank can now be fi lled and inserted into
the device.
3. Set up the device and connect it (see the "Setting Up and Connecting the Device" chapter).
4. Before you enjoy your fi rst espresso or coffee, we recommend that you carry out a trial
run with espresso beans to remove any possible production residues in the grinder and in
the water system. To do this, follow the instructions in the "Operation and Functions" and
"Preparation" chapters.
When the device is fi rst used, production-related additives may cause a small amount of
smoke and / or an odour to be produced. This is normal and not a device defect.
5. Repeat this process twice. Do not drink this espresso!
6. Clean the device and accessories (see the "Cleaning and Care" chapter).

Setting Up and Connecting the Device

PLEASE NOTE!
• Only connect the device to a plug socket that is properly installed. The plug socket must
also be readily accessible after connection so that the connection to the mains can quickly
be isolated. The mains voltage must match the technical data of the device.
• Lay the connecting cable in such a way that it does not become squashed or bent and does
not come into contact with hot surfaces (also applies to the hot surfaces of the device!).
• Do not use the device in conjunction with extension cables.
• Always set up the device with a clear space at the sides (at least 20 cm) and clear space
above it (at least 29 cm) on a fl at, solid and heat-resistant surface that is resistant to
splashing.
• Do not place the device below kitchen wall units or similar cupboards. The rising
steam could cause damage to them!
1. Place the device on the kitchen unit or another dry, clean work surface, following the safety
notices and the notices provided at the beginning of this chapter.
2. Plug the mains plug into a plug socket. The fi eld
mode.
(22) fl ashes. The device is in standby
EN