Skylotec MARK 1 PLUS Gebrauchsanleitung Seite 12

Figure 5.1: HAULING AND PROGRESS CAPTURE
Lead the free end of the rope through the groove at the head of the
brake lever and connect it with a progress capture to the working
end of the rope (fig. 5.1). In working environments always follow
progress with a safety rope.
General information
Regular examination:
• Do not hesitate to retire the device if it shows signs of wear (for
rope abrasion see indicator on the pivoting pulley) or after a major
fall or a major impact. They could cause internal or invisible damage
that may significantly weaken its strength. In case of uncertainty
treat the device as damaged or consult SKYLOTEC.
• Regular periodical inspections should be carried out by an
authorised person at least once a year. For this purpose an
inspection record should be established (see the backside of these
instructions).
Furthermore we would sincerely recommend one set of equipment
is used by one person only as its history of use is best traced and
understood in this way.
• Before each use it is obligatory to check the descender and verify
that all its components (handle, jamming cleat, flanges) are
faultless and in good working condition. Packing, storage,
maintenance and cleaning Each product is packed with its
INSTRUCTIONS FOR USE. Proper maintenance and storage are
imperative to ensure correct functioning of the product (as well as
all your equipment) and thus your safety. Clean the product with a
brush under running cold water of domestic supply. If the stains
persist, clean it in warm water (maximum 30°C) with ordinary soap.
Then rinse thoroughly, wipe it with a towel and dry naturally in a
shaded ventilated place away from sources of heat. If needed, lube
sparingly the moving joints of the jamming cleat and handle with
silicon based oil.
Temperatures
While it is allowed to use this product within the temperature range
from -20°C to 60°C (dry) and -4°C to 60°C (wet), it is advisable to
stock it in a dry place at room temperature.
Lifetime
It is impossible to indicate the exact lifetime of this product for it
depends on frequency and mode of application, on environment
where it is used (marine, cave, corrosive atmosphere), and on
mechanical wear or damage. Provided its correct use (in
concordance with these instructions), the lifetime of the product at
average use is expected to be 10 years.
Guarantee and its limitations
This product is guaranteed for 3 years from purchase against any
faults in materials or manufacture. The guarantee does not apply in
cases of misuse, normal wear and tear, unauthorized modifications
12 12